Sliding rail for door - Aluminium - Roller runners

Chambrelan manufactures this guide rail on the basis of extruded aluminium profiles.
The rail is supplied as standard with a colourless anodised protection.
The rail is equipped with rubber pin stops at both ends. Adjustment of runners :
The rail and runner system is delivered assembled with minimal play and optimal running properties.
We deliver the runner and rail system assembled and therefore pre-set. If a runner is delivered separately, or if it has to be mounted in another rail, or if you have non-standard operating requirements, an adjustment can be made. Please note that a correct adjustment of the runner is essential for the life of the system.
After checking the cleanliness of the tracks, insert the runner without wiper into the rail
– Loosen the adjustment screw of the central roller which is mounted on the eccentric,
– With the rail on edge, turn with the key supplied to obtain the desired setting, then tighten the fixing screw to the torque recommended on the data sheet.
– Check that the runner slides in the rail. The runner should move freely without excessive play.
– Refit the wipers.

Chambrelan specialises in the design and manufacture of telescopic ball bearing slides and guide rails for industrial applications: reinforced slides, linear slides, ball bearing guides, rolling guides, metal runners in steel, aluminium, stainless steel with locking, blocking and in full extension, partial extension, double stroke or super extension for heavy duty industrial drawers, mechanical panels.